3Remove excess grout. Your floor is full of muddy grout, which isn’t a lovely sight. After applying, wait about 15 to 30 minutes for the grout in the joints to set. Then start cleaning:
- Fill two buckets with the water.
- Dip a large grout sponge with rounded corners into the first water bucket and wring it out.
- Wipe in a circular motion or at a diagonal to the grout lines to remove excess grout from the surface of the tiles.
- Rinse the sponge in the second bucket and repeat until all grout is removed from the surface of the tile.
- Wait three hours before repeating the process again. However, don’t wait too long or you have a harder time buffing out the grout haze.
- Make a final pass along the grout lines with the damp sponge to make sure the grout lines are smooth.
- Don’t worry if the excess grout has dried. You can remove it with some basic tools, such as a plastic chisel or putty knife.
Your floor is fully of muddy grout, which is n’t a adorable sight. After applying, wait approximately 15 to 30 minutes for the grout in the joints to set. then start clean :
Reading: How to Grout a Tile Floor
4 Verify the grout color is what you want. Use a hairdryer to promptly dry this small area of grout, so you see how the semblance looks against the install tile. now is the time to make a last-minute exchange, as grout is closely impossible to remove once it ‘s dried .
Read more: Microwave Scrambled Eggs
6Clean up the grout haze once everything is dry. No matter how effectively you cleaned the excess grout from the tiles, you’re likely to have a “grout haze” covering your tiles after your job is done. To clean up the grout haze:
- Use a sponge and a bucket of clean water. Rinse the sponge often.
- Take a dry towel or used rag and wipe at the haze until it begins to cake off. An old sock will work well: you can wear the sock on your hand while you scrub.
- Brush up the residue with a broom.
No matter how effectively you cleaned the excess grout from the tiles, you ‘re probably to have a “ grout haze ” covering your tiles after your problem is done. To clean up the grout haze :
7Wait for the grout to cure before sealing it. Read the manufacturer’s directions to determine how many days to wait. To seal grout:
- Crack the windows to get good ventilation in your room.
- Pour a small amount of sealant on the grout and work it in with a sponge, using small, circular motions.
- Wipe the sealant off after about 5 to 10 minutes, although the time may vary. Check the sealant label to be sure.
- Re-seal the grout every six months to a year if possible.
Read the manufacturer ‘s directions to determine how many days to wait. To seal grout :
Category : How To
Leave a Reply